Click for original picture
Legal status confirmed
Brand:aa
Product detail:
qj-009 best and reliable performance waste wire peeling machine :
| voltage | 110/230 | v |
| power | 1.5 | kw |
| weight | 82 | kg |
| mea. | L620×W440×H650 | mm |
| range | 1~40 | mm |
| daily capacity | 200~1000 | kg |
This machine has 9 inlets, it is apply to single core wires,multicore cables. This machine has the following specifications: * Low power requirement * Small dimensions * Easy to move, place and install * Easy and rapid maintenance
Wire stripper operating(instruction) manual
1.Push the Switch up to turn the Motor ON,Check whether the machine work well.Make sure There are no people on the output side of the machine.Comparing the cables/wires’diameters with the feeding slots on the machine,feeding the cables/wires one piece at one time.Before feeding the cables/wires,please cut off the head of the cables/wires,to avoid gaps caused to the blades.
2.On the output side,if the cuts on the cables/wires are too deep,please check below points:
a, Please adjust the handles on the input side, screw down or loose them. (M12 handles)
b, Check whether the cables/wires on the right position as you feeding them.
c,Make sure the blades are sharp,if not,polish them with the oil stone
3.On the output side,if see the plastic(PVC)has been stripped,but the copper wires can not been disgorged,please check below 4 points:
a,Check whether the springs are loose,if yes, screw down to make them tighten
b,The diameter of the cables/wires are too small,please adjust the space between the two axises to 0.3-0.6mm.
c,If the cables/wires you want to strip are hot,also can not get the copper wires stripped out.
4.If the cables/wires were blocked in the axises,please check below points:
a, check if the Chains are loose.
b, If the springs on the press wheels are too tight,loose them.
c, There are too much oil on the cables/wires,please wipe it(make sure the machine is turned off before wiping.)
1,Wheel adjuster 2,Blades adjuster A: 2 cores flat cables/wires feeding slots B:Diameter 2-5mm cables/wires’ feeding slot C: Diameter 5-10mm cables/wires’ feeding slot D:Diameter 10-15mm cables/wires’ feeding slot E:Diameter 15-20mm cables/wires’ feeding slot F:Diameter 20-25mm cables/wires’ feeding slot G:Diameter 25-30mm cables/wires’ feeding slot H:Diameter 30-40mm cables/wires’ feeding slot Make sure the cables/wires’diameter are similar with the feeding slots ,large cables/wires in large feeding holes,small cables/wires in small feeding slots,flat cables/wires in flat feeding slots.
