Aluminum finned tube finned pipe for Radiator

Brand:aa

Product detail:

Aluminum finned tube finned pipe for Radiator

Technical Parameters
Type of tubes:	Seamless
Base Tube Material:	Stainless or Carbon Steel
Base pipe O.D:	25-165mm
Fin Pitch:	4-30mm
Fin Height:	5-30mm
Fin thickness:	0.6-3.0mm
Soldering Rate:	>98%
Design Temperature:	Below 450°C
Application Pressure:	Max 5.88MPa
Bare Tube Standard:	SA210 SA179 EN10216-2 GB3087

1. Bare Tube Dimensions, Tolerance

    1.1 O.D Tolerance: ±0.8%*Out-Diameter

    1.2 W.T Tolerance:  ± 5%*Wall-Thickness

    1.3 Straightness  :   Tubes be straight with a max deviation of 0.1 in. (2.5mm) in any 10ft. (3m)

section.  

 

2.Tolerance, Requirment of Fin

    2.1 Fin Spacing: The number of fins per unit length of tube shall be as specified, ±2 percent,

measured over at least 12 inches of welded fins.

    2.2 Inclination:  The fin is welded 90 degrees to the tube surface.  Inclination of the fin will not

exceed 5 degrees from the vertical for fin heights.

 

3.Finished Finned Tube Tolerance

   3.1 Stainless Tolerance: Finished finned tubes will be straight with a maximum deviation of 0.2

in. (5mm) in any 10 ft. (3.0 m) section

   3.2 Length Tolerance

              Length ≤ 500mm , +2mm

              500mm <Length ≤ 2000mm, +3mm

              2000mm <Length≤ 5000mm, +5mm

              5000mm < Length≤ 7000mm, +10mm

4.  Fin-to-Tube Weld Requirements

      4.1 Weld Width: The average width of the weld bond between the fin and the tube shall be a
minimum of 90 percent.

      4.2 Weld Bond:  During production, the weld bond on every fifth tube will be tested by removing

one wrap of fin from the trailing end of the tube.  The fractured surface of the fin-to-tube weld shall

be visually inspected, and the arithmetic average width of the weld bond as evidenced by the white

metal exposed shall be no less than 90 percent of the measured fin thickness. If the arithmetic

average width of weld bond is less than 90 percent, the weld bond of the previously finned tube

will be checked, (back to the previously inspected 5th
 tube, if necessary), until weld bond that averages 90 percent is found. In the event of disagreement

on the visual inspection, a tensile test of the fin-to-tube weld on a representative sample yielding the

minimum average values, based on the measured fin thickness, shall be considered evidence of an acceptable weld.

 

Fin tube heat transfer area is 8 times than the light tube, high efficiency heat exchanger, more advanced than the other heat exchanger products.

Applicaton: Boiler Economizer, Heat Exchanger, Power Plant Waste Heat Boiler,

Petrochemical Engineering.  

Different kinds of finned tubes can be developed and designed according to your

requirements in good quality

 

 

MORE ENERGY-EFFICIENT AND ENVIRONMENTAL! 

WE ARE TRUST WORTHY! WAITING FOR YOUR EARLY REPLY!

 

 

 

 

Real product show

 

 

The machine is working