Click for original picture
Legal status confirmed
Brand:aa
Product detail:
Water Chiller for Plastic Molding Machine
Introduction
Air-cooled industrial chillers are widely used in the plastics industry, where precision temperature control is required when cooling molds to achieve higher quality of the product surface finish and lower cycle time. Air cooled chillers are also intended for numerical-controlled (NC) lathes, die-casting machines, lasers, foodstuff and medical apparatus, and plating process machines.
Technical data sheet
Model | Unit | MG-10C(D) |
Nominal cooling capacity | kcal/h | 22842 |
KW | 26.56 | |
Input power | KW | 10.75 |
Set temp. range | 5ºC~35ºC | |
Power supply | 3PH-380V-50HZ | |
Refrigerant | Type | R22/R134a/407c |
Type of control | Thermostatic expansion valve | |
Compressor | Type | Hermetic scroll |
Power(kw) | 4.55*2 | |
Condenser | Type | Finned copper tube+low noise outer rotor fan |
Cooling air flow(m3/h) | 10000 | |
Evaporator | Type | Tank with coil/shell and tube |
Chilled fluid flow(m3/h) | 4.57 | |
Volume(L) | 200 | |
Inlet and outlet pipe diameter | 1-1/2" | |
Pump | Power(kw) | 0.75 |
Lift(m) | 20 | |
