Verified Company
Shenzhen Hong Ye Jie Technology Co., Ltd.
Click to enlarge
Addition Cure Silicone Rubber for Concrete items Application:
Addition Cure Silicone Rubber for Concrete items is mainly applied for making various molds:
Addition Cure Silicone Rubber for Concrete items can be used to reproduce concrete or cement, gypsum, gypsum, architecture, decorative arts and crafts, big statue, cultural relic product, etc.
Addition Cure Silicone Rubber for Concrete items can be used to reproduce poly resin, epoxy, polyurethane-polymer, plastic toy, gift and stationery.
Addition Cure Silicone Rubber for Concrete items can also be used to reproduce soaps, candle & lighting.
Addition Cure Silicone Rubber for Concrete items FEATURES:
- Addition Cure Silicone Rubber for Concrete Crafts has an exceptional fluidity and good operability.
- Addition Cure Silicone Rubber for Concrete Crafts has good Temperature and deformation resistance as well as low shrinkage.
- Addition Cure Silicone Rubber for Concrete Crafts has High duplication times.
Addition Cure Silicone Rubber for Concrete items Operation:
- Step One to use E642#: Take 100g of part A and add 100g of part B and mix the silicon rubber and the curing agent evenly.
- Step Two to use E642#: vacuum pumping
- Without exception, this takes less than 10 minutes. Otherwise, it will cause cross linking reaction, and no more further steps will be available.
- Step Three to use E642#: Brushing cast & Perfusion Molding operation.
Addition Cure Silicone Rubber for Concrete items Datasheet:
Usage: Silicone rubber for PU/poly resin products, plaster, candles, gypsums crafts, cement products, concrete/architectural products, statuary, casting molds making, etc.
| Model | Component | Colour | Mix Ratio (%) | Viscosity before Mix(cps) | Viscosity after Mix(cps) | Hardness (A0) | Pot Life | Curing Time | Tensile Strength (kgf/cm2) | Tear Strength (kN/m) | Elongation (%) |
| E642# | A | Translucent | 1 | 20000 | 8200 | 42+/-2 | 30Min/25°C | 2-3Hrs/25°C | 80+/-20 | 10.4 | 350+/-50 |
| B | Translucent | 1 | 3500 | 20Min/60°C |
Do you meet the following problems when making silicone rubber molds?
1. Why the silicone mold just can be reproduced for a few times?
2. Why does the silicone mold appear to be dry outside but wet inside?
3. Why does the silicone mold get burnt out?
4. Why the silicone mold appear with weak tear strength?
5. Why is the silicone mold oily?
Further information, please feel free to contact Firleanna:
SKYPE:HY-Firleanna
T: 86-755-89212365
M:86-18938867520
F: 86-755-89948030
3w(dot)szrl(dot)net
3w(dot)sellsilicon(dot)com