Hydraulic Vehicle Positioning Jack (4in1, with bracket)

The Easiest Way to Move Automobiles around your Garage!

Basic Parameters:

2 pcs & 4 pcs hydraulic vehicle positioning jack with bracket

Widely Used go jack 

Applicable:Car work shop, Car tool shop, Car maintenance shop, DIY Car enthusiasts, etc.

Vehicle Positioning Jack Picture:

 Widely Used go jack

Functions:

Versatile positioning jacks allow a single person to move cars, trucks and ATV's around the repair facility with ultimate flexibility. There is no need to jack the vehicle up and place dollies under each tire, as each unit combines a jack and dolly together in one simple piece of equipment. Perfect for moving vehicles under repair or restored automobiles in confined spaces, dollies allow cars to roll backwards, forwards and sideways easily. Foot-operated hydraulic jack squeezes the support legs together, smoothly and safely lifting the tire off the ground in seconds.

Hydraulic vehicle positioning jack practical display 

Widely Used go jack 

How to use this Hydraulic vehicle positioning jack?

Step 1. Place Jack on floor and press down on pedal to release pedal lock. Pull out the lock pin from frame

Step 2. before operating, open release valve by turning handwheel counterclockwise. Expand Jack by hand-wheel enough to place around tire and position so both rollers now contact the tire tread. To obtain the best control of Jack while expanding around tire, place your left had on top of the left side axle and your right hand at the center of the pedal. Close release valve by turning handwheel clockwise to a snug-tight position, Jack may now be used.

Step 3. Install Jack so that the unit is parallel to the sidewall of the tire to be lifted. Leave approximately 3/4" of clearance between tire and Jack. This is very important. If unit is misaligned, it is possible that the tire will be forced to hit the axle of the Jack and not the rollers, this may damage the Jack and void the warranty.

Step 4. To lift tire, flip directional lever up and place foot on pedal depressing with smooth, even strokes. Cycle pedal until tire is lifted from surface one inch or less. After lifting, the lower the tire is to the ground the more stable Jack will be. After lifting, be sure always lock the pin in place before operating. Repeat process on the other tires and maneuver the vehicle as required.

Step 5. To release Jack, pull the pin out from frame and open valve by turning handwheel counterclockwise slowly. Jack may be removed when rollers disengage from tire.

For more details please visit www.densoautoac.com, or any questions please call me 86 755 23215133