Click to enlarge
一、Features
1. Good flexibility and viscosity;
2. Construct under damp environment;
3. Good permeability, good ageing resistance and corrosion resistance;
4. No toxicity, no nocuity it’s a new eco-friendly product.
二、Applications
1. Various pipes, expansion points, structural cracks, cement fiber board and meta l board;
2. Rooftop, balcony, basement, bathroom, water tank, swimming pool, metro and tunnel.
三、Surface finishing
1. Keep the surface plane, solid, clean without oil dirt, dust or other loose matters;
2. Obvious gap and hole should be filled by cement mortar and sharp edges must be eliminated;
3. Wet the base material till no seeable water;
4. Newly-cast concrete should take some time to dry and maintain to avoid concrete shrinking;
5. Old concrete surface must be cleaned by water and then coated.
四、Technical Process
1. Pour the powder agent into the liquid and keep stirring till no granules or bubbles could be seen;
2. Use brush or rolling brush to coat the paint on the base surface, keep stirring in a interval to avoid depositing;
3. Two times of brushing is needed (two directions), the final coating film should have 1.0-1.2mm depth, 1-2kg/m2;
4. It’s advised to use non-woven fabric or fiberglass to strengthen the viscosity at the joint and crack to enhance the extension; if the film is stuck on the ceramic tile directly, it must coat the surface to make the film fully cover the base material.
五、Cautions
1. Ensure the base material is fully covered and other works could be conducted in 24 hours;
2. For those areas where have higher requirements to the abrasion performance, it needs to add hardening layer to protect the film;
3. Construction temperature: 5~40℃
4. Do NOT add water into the dried mortar for second use.