perforating slitting rewinding machine or called perforatting slitting rolling machine or perforating cutting rewinding machine or nonwoven cutting rewinding dotted line machine and so on.

This machine can be divided into two kind:produce product(for example: bottled wipes ),produce small roll.

Our company aways design the machine according to clients' requirements.

Detail Introduction:

1. 1.    Device functionality: perforating, counting (display on the touch screen), slitting, rewinding at the same time. The end face is neat.
2. 2.    The machine punch cutter shaft, the effective width can be customized, independent drive servo motor, anti-jamming system with timing belt, perforated spiral wire cutter shaft (punch knife the size of the specifications provided by the customer), balance, and can adjust the perforating slope, perforated pitch can be adjusted from 10cm above (setting on the touch screen).
3. 3.    Slitter shaft and closing roller with a servo motor with synchronous belt drive, the knife shaft material hardness and toughness are enhanced, so as to easy changing of the upper and lower knives.
4. 4.    Slitting and perforating must add the guide roller device, the guide roller material selection aluminum alloy, less than 80mm in diameter and can rotate freely.
5. 5.    Winding rollers and cutter axis with a servo motor with belt drive, two winding roll diameter of 220mm, two winding roller in which a driven roller was equipped with a gear-type continuously variable control the speed of rewinding roller.
6. 6.    Winding roller with air pressure on both sides of the two cylinder compression adjustment device, with a diameter of 76mm inflatable shaft winding, two stainless steel shaft winding.
7. 7.    The machine is consist of  three parts, perforating device, slitting device, rewinding device, the various parts of the roller shaft with 38mm thick steel surface spray paint, bearings be installed in the shell bearing as the equipment on both sides of the support frame, and steel plate fixation with a steel plate between the two parts with screw securely connected.
8. 8.    PLC programming, computer touch screen control, unwinding part, perforating part, slitting and rewinding part of the three parts of the motor encoder and PLC programming, before and after either each part individually adjustable also can joint adjustable.
9. 9.    The pneumatic roller unwinding, with rocker corrective. Feeding with a pneumatic automatic volume.(Rocker from the ground to the lowest 10cm)
10. Produce core, coreless roll product, Perforating Rewinder or not perforated, available on the console touch screen operation, also available button operation.
11. Product slitting width adjustable 30mm above finished maximum diameter of 400mm (400mm less adjustable), 15 sets of upper and lower knife with online slitting, cutting size can be adjustable within a certain range.

According to production needs, was equipped with the 1-3 servo system, in order to achieve maximum production efficiency and guarantee the quality of the product.