Product instructions:

1, install the blade Will first transparent film on the top of the machine, turn the handwheel "wide, narrow" banners, the orbit to both sides, take off the screws on the top of the knife dish, take out the cover of the knife blade under the surface of the wipe, the blade flat end up on the cutter disc, mounted on the back cover, lock screw tight.

 2, adjust the feet length cutting On side of the "long - short segment lifting wheel, adjustment to the required position (should definitely be careful not to let the blade at the bottom of the upper run into orbit of).

 3, adjust the rolling way To the width of the production of circuit boards, turn the handwheel "wide, narrow" banners, the distance between good track.

4, and began to cut the circuit board into the orbit of into the plate, take "switch" ON ", push the handle to cut the foot, at the bottom of the handle is pushed, the anchor point, return the in situ, put down the PCB again, push the handle, so repeat, circuit board out of orbit at the other end.

There is no single perfect material. Many factors are involved in selecting right material to match your cutting application. Skill and experience are necessary to know what material is best for your application, environment, processing, etc. following as a guide: