Click to enlarge
Glass Block Spacer:
Plastic spacer for glass block:
Size | 80X6mm,80X10mm,95X10mm |
American size: | 3-1/8 x 1/4, 3- 7/8 x 1/4-inch and we have two half spare for US market |
Materil | ABS,PS,PP |
Suitable for | 80mm, 95mm and 100mm Thickness Glass Block |
provide a 1/4" ,10mm mortar joint | |
Packing | 25PCS/polybag,8polybags/carton |
Qty/20’Container | 196,000PCS |
Payment Terms | 1.30% payment in advance, the balance 70% paid at sight after receiving copy of B/L 2. 100% against irrevocable L/C at sight |
Delivery Time | 15days |
We supply injection mould & various plastic products. produce according to customer's drawing/sample.
OEM&ODM Service are available!
Glass block install instructions:
Use one Glass block spacer per each corner of glass block. Depending on your glass block wall design you will need:
9 spacers for 4 blocks
12 spacers for 6 blocks
15 spacers for 8 blocks
20 spacers for 12 blocks
42 spacers for 30 blocks
- Cut legs and tabs off spacer to fit application:
L-spacer (use for corners of wall)
--Remove both tabs and two legs from each side.
T-spacer (use against jamb and header)
--remove both tabs and both legs
- Apply glass block mortar/grout pre mix to still first, then to vertical side of block.
Set glass block against spacer and repeat this step until job is finished.
- Smooth joins and clean up with wet clean cloth before mortar completely sets.
- Twist off all tabs after mortar completely sets.
- Apply joint mortar.
Glass block spacer are also ideal for curved glass block walls. Simply establish your curve and make sure the edges of the glass blocks are tight against the vertical arms of the spacer on the inside of the curve.